pc1p's latest activity
-
I don’t really disagree. I just don’t like putting in parts and hoping for the best. Give me the ability to dial everything in. I’m... -
pc1p replied to the thread Caster question.It certainly can argued for or against validly... For me it depends on the rig. On a JKU, where the arm geometry is pretty decent and...
-
Personally, I would not do a lift without adjustable lower control arms. Even a 2 inch lift. Although I do agree you can. Just in my...
-
pc1p replied to the thread 2008 JKU "Argenta" Build Thread (plus a 2010 Islander side project).I went back and cleaned up all the wiring for the transmission and shifter. I ended up using a small aluminum plate under the glove box...
-
-
pc1p replied to the thread Caster question.No - your caster angle is the difference between true 0° and imaginary line that runs through your balljoints centerline when viewed...
-
-
pc1p replied to the thread Caster question.Caster is measured against true vertical. Assuming your angle finder was zero'ed out appropriately, it's very likely the cause of your...
-
-
pc1p replied to the thread 2008 JKU "Argenta" Build Thread (plus a 2010 Islander side project).Some good news - I was able to test crank (not start, just crank!) the engine! I got the C3 connector (the body harness portion of...
-
-
I thought I’d write a final update now that I’ve finally got the Jeep running again. I went through quite a few stages during the...
-
pc1p replied to the thread 2008 JKU "Argenta" Build Thread (plus a 2010 Islander side project).Well, what I was afraid of has happened - the delays have pushed the Hemi swap into the spring and into my second busiest time of the...
-
-
UPDATE: Rplace the thermostat with Jeep OEM. Spent 2 hours burping with the nose in the air. Now 5 days at normal temperature. Bad...
-
Thanks for closing the loop on this. Hopefully you don't experience any additional issues!
-
pc1p replied to the thread Overheating from heat soak.I can't tell the mounting situation on that radiator that you're using, but a Camaro Fan + Lingenfelter Controller is a solid choice...
-
-
Quadratec, Extreme Terrain, might even try an RV dealer near you, since most RV doors use the paddle latches
-
pc1p replied to the thread Overheating from heat soak.Depends on who you ask and what you're referring to (i.e. oil temp or engine temp)... modern engines and modern lubricants are designed...
-
Four days with a perfect result! At least you have that trophy. Well done and thanks for the details.
