Recent content by Mr.T

A real off-road getaway no cell phone coverage, on water, one male and female toilet. You have take everything in and out. I took 30 gallons of water, solar panel, 500w power station, electric water pump, hot water heater and shower toilet tent. Plus lots of camping stuff.

Some tire shops would not rotate my tires because of the spacers. I don’t have that any more.

None because of the offset. I had 1.5” spacers with my stock rims.

285/70R 17 are what I have with Dick Cepek rims

Yes I see. My need just a little more pulling my trailer with 4x5x2 box full of camping gear, 30 gallons of water for hot showers, sink. You could say 5 star camping is better then ruffing it. I am ok pulling it on paved or gravel roads with 3.21gear. Off road #2 or #3 trails or desert sand is...

Currently running 3.21 gears, 32.7 tall tires with Sprintex Supercharger Dyno test at 375 horsepower. Thought about 3.73 gears but am Re-gearing to 4.11. RPM will change at 70 to 2453 and 2804 at 80. I can live with that and with the extra HP it will not be sluggish.

With a stock setup the PCV work fine but if you start adding mods things change. Installing a supercharger or turbo you can get blow by and the vacum to the PCV is greater too. see post where I installed 2 catch cans.

just install two oil separators (catch can) on my 2017 JK two door. Why two, I have a Sprintex Supercharger installed. One on the PVC to intake side and the other on the clean air inlet to air filter box side because of engine blow by created by the supercharger. Sprintex Supercharger PVC Side...

yes first pull 297 HP before any tuning. I plan on keeping my jeep a long time.

I did switch from DiaboSport Tune to HP Tune. I just got my Jeep Tuned and Dyno Tested in El Paso, TX See Print out for Low and High pulls.

I moved the Crankcase Breather Filter to a better place on the Airaid box. See PDF

I went with

After installing a Supercharger I am thing of putting on decals, one on each side of hood like the Rubicon decals or front of windshield. Please give some input.

Got the 3.5 in. O.D. piece of aluminum 45 mandrel bend pipe. This will work better then the PVC, more CFM.

64% more Horsepower; 195 WHP stock to 319 WHP and 38% more torque; 239 lb/ft stock to 329 lb/ft